6
I.PRODCT INTRODUCTION
- Control Lock (10). This pad allows locking all the control panel to simplify the cleaning
but also to preserve and safe children from all risks.
II. USING YOUR APPLIANCE
a) Use of the control panel
- The sensitive pads work with a sense of touch. It is not necessary to put pressure on.
- Use the base of your finger and not the tip as indicated on the images below
- Slide your finger on the slider to increase or decrease the power.
- You will hear a beep each time an action will be registered.
- The control panel must be clean, dry and not be covered by an object or a cloth; even a
thin layer of water can create dysfunction.
b) Starting your appliance
After the power supply is connected, the buzzer sounds and the screen show "L" or "H" blinking,
indicating that the hotplate is in a state of standby. So that the appliance is ready to be
programmed, press on On/standby (7). After pressing this button, the induction cooker enters
standby mode. Then you can press the function button to enter the working mode.
Never put an empty container on the ceramic plate before switching on the appliance.
Note:
Under the standby mode, if no function button is pressed for about 60 seconds, the induction
cooker will switch off automatically.
Under the working mode, if there is no proper pot on the ceramic plate, the induction cooker will
switch off automatically a few seconds later(no more than 10 seconds)
c) Power function
In order to select the power intensity you can:
- Either press the + (8) or - (9) buttons
- Or press the slider, by swiping your finger from left to right on the button.
To guide you, lights appear above each power level.
To Next Page
Loading...
Need help?
General
