Models and static dial code table :
NO.
Fault Name
1
2
Main board LED light
Fan failure
LED light flash 4 (flashing frequency 2Hz) stop 2s, cycle of action
Not set models LED light continue to flashing(flashing frequency 2Hz)
200CFM(34WA)
300CFM(51WA)
400CFM(68WA)
500CFM(85WA)
600CFM(102WA)
800CFM(136WA)
1000CFM(170WA)
1200CFM(204WA)
aP21 aP03
single-m otor
double-m otor
MODE
Static
pres sure
single-m otor
single-m otor
single-m otor
single-m otor
double-m otor
double-m otor
Not
set models
10.2 The default model of DC fan coil is set as 12Pa when leaving the factory.
Clients can dial to the responding position to choose the model and static pressure according to the nameplate and actual static
pressure requirements of the models and static dial code table .
When the unit is subject to failure, main board corresponding LED will flash.
Fault code table and Protection:
10.3 Fault and Protection
aP05
9
Owner’s & Installation manual
The A-weighted sound pressure level is below 70dB.
10.4 Tables
To Next Page
Loading...
Need help?
General