Midea MOU-36HFN1-M - Page 89

86
box
3
Remove
the PCB
1) Take out the
electronic control
box from the body
and remove its cover
Repeat the operation of step1, step2 and step3 of No2.
2) Disconnect all the
wires of plugs
connected to the
PCB
3) Remove the PCB
from the fixing pins
4**
Remove
the PCB of
outer
driver DC
motor
1) Remove the air
return grille
Repeat the operation of step1 of No2.
2) Screw off the screws
to take out the
electronic control
box from the body
3) Disconnect all the
wires of plugs
connected to the
PCB
4) Screw off the screws
to remove the PCB
5.
Remove
the fan
motor
1) Take out the
electronic control
box from the body
Repeat the operation of step1 and step2 of No4.
Each corner has
a fixing pin
2 screws
2 screws
Electronic control box