41
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use Basic Functions section of this manual.
Buttons and Functions
Model:
RG10B(B2)/BGEF
(Fresh feature is not available)
RG10B10(B2)/BGEF(20-28°C/68-82°F).
Description
ON/OFF
No.1
No.3
No.4
No.5
No.6
No.8
No.2
No.7
No.9
No.10
Turns the unit on or off.
TEMP
Increases temperate in 1°C (1°F) increments.
Max. temperature is 30°C (86°F).
NOTE: Press together & buttons at the same time
for 3 seconds will alternate the temperature display
between the °C & °F.
SET
Scrolls through operation functions as follows: Fresh( )
Follow Me( ) AP mode( ) Fresh ....
The selected symbol will flash on the display area,
press the OK button to confirm.
No.11
No.12
No.13
No.14
Turbo
1
7
8
9
10
11
12
13
14
2
3
4
5
6
TEMP
Decreases temperature in 1°C(1°F) increments.
Min. temperature is 16°C (60°F).
FAN SPEED
Selects fan speeds in the following order:
AUTO
LOW
MED
HIGH
NOTE: Holding this button down for 2 seconds will
activate Silence feature.
SWING
Starts and stops the horizontal louver movement. Hold
down for 2 seconds to initiate vertical louver auto swing
feature (some units).
MODE
Scrolls through operation modes as follows:
AUTO
COOL
DRY
HEAT
FAN
NOTE: HEAT mode is not supported by the cooling only
appliance.
SLEEP
Saves energy during sleeping hours.
OK
Used to confirm the selected functions
TIMER
Set timer to turn unit on or off.
SHORTCUT
Used to restore the current settings or resume previous
settings.
CLEAN
Used to start/stop the Self Clean or Active Clean function.
(Model dependent, please refer to the USER’S
OPERATION & INSTALLATION MANUAL).
LED
Turns indoor unit’s LED display and air conditioner
buzzer on and off (modeldependent), which create a
comfortable and quiet environment.
Turbo
Enables unit to reach preset temperature in shortest
possible time
Turbo
To Next Page
Loading...
