To Next PageTo Next Page
Need help?Do you have a question about the Midland BIKEPLAY GUARDIAN and is the answer not in the manual?
Avoid high-pressure water, alcohol, and corrosive solvents for cleaning.
Ensure all units are connected before powering on.
Avoid folding cable lines during installation.
Use certified 32-256GB Class 10 U3 TF card, format before first use.
Regularly format the memory card to prevent fragmentation.
Secure rubber plugs after insertion to maintain waterproofness.
Tyre Pressure Sensors require installation on tyres before pairing.
Insert the memory card before using the device.
Remove and replace the lower screen cover to access the slot.
Wiring method connecting to the motorbike battery.
Wiring method connecting via USB.
Pair your smartphone with the device using Bluetooth.
Select the appropriate operating system for CarPlay.
Enable CarPlay functionality on your phone.
Pair your smartphone with the device using Bluetooth.
Select the appropriate operating system for Android Auto.
Android Auto should automatically pair after initial setup.
Details on recording time, resolution, GPS, WiFi, and G-sensor status.
Adjust screen brightness and audio volume.
Access camera views and settings.
Connect to Apple CarPlay.
Connect to Android Auto.
Access panel settings.
View recorded videos.
Navigate to the main settings menu.
Connect to Bluetooth devices.
Configure Tire Pressure Monitoring System settings.
Choose between Km/h and Mp/h for speed display.
Configure the screen saver delay time.
Select the user interface language.
View current GPS signal status and information.
Set or synchronize the device's time automatically.
Enable or disable the touch key sound.
Toggle the device's WiFi functionality.
Format the inserted memory card.
Choose audio output source (device or phone).
Restore the device to its original factory settings.
View software version, Bluetooth, and WiFi details.
Turn off Bluetooth on both the device and smartphone.
Activate WiFi on the Midland BikePlay Guardian.
Connect smartphone to the 'Midland BikePlay' WiFi network.
Enter the default password '12345678' to connect.
Open the KYCAM2 application.
Steps to disconnect CarPlay or Android Auto.
Reconnecting after a manual disconnection.
Reconnecting after device restart.
Troubleshooting steps for a blue camera display.
Information on using the device without cameras.
Troubleshooting steps for the device not powering on.
Troubleshooting sensor pairing issues.
Device operating frequency.
Device power output or consumption.
Device's ingress protection rating (IP67).
Supported screen mirroring technologies.
Supported video recording resolutions.
Number of cameras supported (front and rear).
Details of the device display.
Availability of WiFi and app connectivity.
Confirmation of GPS tracking feature.
Supported video and compression formats.
Supported memory card sizes and classes.
Required voltage and power input.
General
