Replacing the lid
If the lid has been removed in order to
fit a coverplate, ensure that, if the lid is
ever replaced, it fits securely into the
rear holders. Otherwise, it is not
properly secure for transport.
Levelling the machine
The machine must be perfectly level to
ensure safe and proper operation.
^
The screw feet can be adjusted to
compensate for any unevenness in
the floor.
,
At the front of the dryer: Room
air to cool the condenser unit is
taken in through the opening in the
hygiene filter panel. This opening
must not be blocked or covered over
as this would cause a fault.
Installation and connection
40
To Next Page
Loading...
Need help?
General
