en - Warning and Safety instructions
33
objects and do not brush the fine dust filter. After clean-
ing, leave the fine dust filter to dry for a minimum of
24hours before placing it back in the fine dust con-
tainer.
– Pre-filter / filter frame: rinse under running cold water.
Do not use washing-up liquid. Do not use any sharp or
pointed objects. Dry thoroughly after cleaning.
Correct use
Do not use the vacuum cleaner without the dust con-
tainer, pre-filter, fine dust container and fine dust filter fit-
ted.
Do not vacuum up anything which has been burning or
is still glowing e.g. cigarettes, ashes or coal, whether glow-
ing or apparently extinguished.
Do not use the vacuum cleaner to vacuum up any water,
liquid or damp dirt. Wait until any freshly cleaned or sham-
pooed rugs or carpets are completely dry before attempt-
ing to vacuum.
Do not use the vacuum cleaner to vacuum toner dust.
Toner, such as that used in printers and photocopiers, can
conduct electricity.
Do not vacuum up any inflammable or combustible li-
quids or gases and do not vacuum in areas where such
substances are stored.
Do not vacuum at head height and do not let the suction
get anywhere near a person's head.
To Next Page
Loading...
