Miele Complete C3 Active User Manual

en
52
To regulate the suction power
The suction power can be regulated to
suit the type of flooring being cleaned.
Reducing the suction power reduces
the amount of effort required to man-
oeuvre the floorhead.
The vacuum cleaner has symbols on
the controls which indicate the type of
use the settings are suitable for.
The setting selected will light up yellow.
 Curtains, fabric
 Upholstery, cushions
 Cut pile carpets, rugs and run-
ners
 Energy-saving vacuuming. This
setting is also very quiet
 Loop pile carpet and rugs
 Hard flooring and heavily soiled
carpets and rugs
When using the adjustable floorhead,
if the suction seems too high, reduce
the suction power until the floorhead
is easier to manoeuvre.
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following suction power se-
lectors.
- Footswitches
- Footswitch with the option of select-
ing interim suction power levels
- Footswitch with Boost function
- Radio-control handle
- Radio-control handle with Boost
function
Foot controls (Fig. 25)
The first time the vacuum cleaner is
switched on, the highest setting will be
selected automatically.
After that the vacuum cleaner will
switch on at the setting which was used
previously.
 Press the + foot control to select a
higher setting.
 Press the - foot control to select a
lower setting.
Footswitches with the option of se-
lecting interim suction power levels
Some models also offer the option of
selecting power levels in between the
standard 6 settings.
To activate this function
 Press the + footswitch until the max-
imum power level has been reached.
 Keep the – footswitch pressed until
the symbol for the lower power level
starts to flash.
 Then release the footswitch.
You can also activate this function
from the lowest power level. To do so
press and hold the + footswitch, until
the symbol for the higher power level
starts to flash.
To select an interim power setting
 Press the – or + footswitch until the
required power level has been
reached.
After a minute without touching a con-
trol, the suction power interim setting
will be saved to the next highest or low-
est setting. The flashing will stop.

Miele Complete C3 Active Specifications

General

AC input voltage	230 V
AC input frequency	50 - 60 Hz
Maximum input power	890 W
Annual energy consumption	- kWh
Cord length	8.5 m
Dust container full indicator	Yes
Type	Cylinder vacuum
Cleaning type	Dry
Dust capacity	5 L
Product color	Red
Tube lock type	Click
Number of wheels	3 wheel(s)
Dust container type	Dust bag
Proper use	Home
Noise level	- dB
Cleaning surfaces	Carpet, Hard floor
Vacuum air filtering	Miele AirClean
Dirt separating method	Filtering

Weight and Dimensions

Depth	284 mm
Width	496 mm
Height	227 mm
Weight	7300 g
Package depth	320 mm
Package width	590 mm
Package height	380 mm
Package weight	8700 g