Miele CVA 4060 - Descaling the Machine

To run the descaling programme
Please fill with fresh water
Descale n Settings F
^
If you want to descale the machine before it has heated
up, use the right hand control to select "Descale" from the
initial menu and then press the right hand control to begin
the descaling programme.
^
If you want to descale the machine without being
prompted to do so by the reminder (because your water
is very hard, for example), select the "Maintenance" option,
MAINTENANCE RINSE CAPPUCCINATORE
-
RINSE SYSTEM
CLEANING
DESCALE
H
^ Turn the right hand control until "Descale" is highlighted and
then press the control.
The display will guide you through the whole procedure.
Please follow the instructions to, for example, empty the drip
tray, fill the water container etc.
If the machine has already heated up, it will cool down
for approx. 10 minutes before starting to run the
descaling programme.
The descaling programme cannot be cancelled once the
right hand control has been pressed. The programme has
to be completed through to the end. This is a safety
measure to ensure that the machine is fully descaled, and
is important to protect the machine and ensure it functions
correctly.
^
When the message appears in the display asking you
–
to add descaling agent to the water container, take the
water container out and fill it up to the k mark with cold
water. (Do not use less water than this because this
would cause the descaling programme to finish before it
has been completed properly).
Descaling the machine
68
Downloaded from CoffeeMachineManual.com Manuals