The message "Check brew unit" appears on the display?
Possible fault Solution
The brew unit is clogged.
–
Follow the display prompts.
–
Clean the brew unit (see "Cleaning
and care" - "Brew unit").
–
Set the amount of ground coffee and
the grinder setting to the medium
settings, also adjust these settings in
the user profiles. See the respective
chapters in this manual.
The message "Fault - 28" appears on the display?
Possible fault Solution
If too much ground coffee passes
through the coffee chute the machine is
unable to process it so it can be emptied
into the waste container.
–
Tap the button next to OK.
The machine is again ready for use.
One of the messages "Fault - 1" to "Fault - 4" or "Fault - 80" to "Fault - 83"
appears in the display.
Possible fault Solution
Use the On/Off button to switch off the
appliance and wait approx. 1 hour
before you switch it back on.
If the message still appears, contact
Technical Service.
One of the messages "Fault - 74" or "Fault 77" appears in the display.
Possible fault Solution
Switch off the appliance, wait a short
while, then switch it back on.
If the message still appears, contact
Customer Service.
Frequently asked questions
63
To Next Page
Loading...
