Technical Information
27
CVA 4062/CVA 4066/CVA 4068 Coffee Systems
Remedy:
Since machine no. 81467600, an improved dispenser (mat. no. 07353230) has been
installed.
Replace the defective dispenser with this new dispenser, if necessary.
Cause:
The rubber stoppers have become loose and gotten stuck in the machine when the
dispenser is removed.
Remedy:
Remove the stuck rubber stoppers from the machine. Re-insert them in the nozzles.
Insert the dispenser back in the machine.
Cause:
Rubber stoppers in the dispenser nozzles were not removed when the dispenser was
cleaned.
Remedy:
Remove both rubber stoppers from the dispenser nozzles.
Clean the stoppers and the nozzles; see the operating manual.
Advise the customer about the cleaning instructions in the operating manual.
Cause:
Milk container inserted incorrectly.
If the milk container is crooked or not inserted deeply enough, air can be drawn into
the milk hose. This will lead to unsatisfactory milk froth.
Remedy:
Insert the milk container correctly.
Cause:
Drip tray grid incorrectly inserted.
Remedy:
Insert the drip tray grid correctly.
To Next Page
Loading...
Need help?
General
