Miele DA 196-2 - Retaining Plates Installation

Retaining plates
There are three retaining plates A, B and
C for fixing the cooker hood to the wall.
First of all drill the holes for attaching the
canopy and for fitting retaining plate A.
^ Before fitting the retaining plate draw
a vertical line centrally above the hob
on the back wall.
^ Mark measurement S from the hob
surface upwards (see "Appliance di-
mensions"). This marks the height of
the lower rim of the cooker hood.
^
DA 196-2:
Drill an 8 mm C hole on the middle
line, 18 mm above the height marked
S. Insert an S8 plug into the hole.
^
DA 199-2:
Drill two 8 mm C holes, 18 mm above
the height marked S and 250 mm right
and left of centre. Insert S8 plugs.
Retaining plate A
^
Drill two 8 mm C holes, one at
S + 100 mm and one at S + 425 mm
on the centre line for the retaining
plate (see "Appliance dimensions").
Insert S8 plugs.
Installation
18