Cleaning and care
36
After cleaning
After cleaning, leave the filters to dry
on an absorbent surface before
replacing them.
When removing the panel and filters
for cleaning, also clean off any
residues of oil or fat from the now
accessible parts of the casing to
prevent the risk of these catching fire.
Replace the grease filters, making
sure that the locking clips are facing
down towards the hob.
If a grease filter is inadvertently
replaced upside down, insert a small
screwdriver blade into the slit to
disengage the clip.
Lift the panel into the deflector plate
and hook it in at the back.
Lift the panel upwards at the front
and press it into the locking clip.
The panel can also be turned 180° and
fitted. Depending on where the cooker
hood is installed, this can make it
easier to remove and refit the panel.
To Next Page
Loading...
