Operation with an external motor (...EXT
models)
^
If a C 150 mm exhaust ducting has to
be used, adapt the stub by cutting it
off at the join with a sharp knife (see
illustration).
The exhaust stub does not need to
be adapted if C 125 mm ducting is
being used.
It has an integrated non-return flap.
Building in
The cooker hood is intended to be
built-into wall units, cooker hood
housing units, and above breakfast
bars or island areas.
Check prior to installation that the top of
the appliance will be accessible after
installation.
If this is not the case, install the exhaust
ducting and prepare the electrical
connection and the connection to the
external motor (...EXT models only)
before installation.
^
Place the appliance, as illustrated, in
the cut-out from below and align it.
Installation
23
To Next Page
Loading...
