a Extension piece
b Tower
c Canopy
d Control panel
e Grease filter
f Recirculation grille
(only for recirculation mode)
g Hob lighting
h Charcoal filter
(special accessory for recirculation
mode)
i Hob lighting switch
j Sliding switch for the fan
To switch on, slide the switch to the
required setting.
Depending on the intensity of the
cooking vapours, levels "1" to "3" are
usually sufficient for normal cooking.
For short periods of intensive cooking
vapours, e.g. when searing meat, you
may wish to select the Intensive
Setting "IS".
It is advisable to run the fan for a few
minutes after cooking is finished to
neutralise any lingering odours in the
air, whether you are using air extraction
or recirculation mode.
To switch the fan off, slide the switch to
position “0”.
Guide to the appliance
11
To Next Page
Loading...
