–
The water pressure (flow pressure at
the take-off point) must be between
30 and 1000 kPa (0.3 and 10 bar).
If the water pressure is lower than
this, the fault message
Water inlet
fault
will appear in the display (see
Problem solving guide).
If the water pressure is too high, a
pressure reducer valve must be
fitted.
After connecting the dishwasher to
the water supply, check that all
plumbing connections are
watertight.
,
To avoid any damage to the
appliance, the dishwasher must only
be connected to a fully vented
plumbing system.
! The inlet hose must not be
shortened or damaged in any way
as it contains electrical components
(see illustration).
Plumbing
64
To Next Page
Loading...
