EasyManua.ls Logo

Miele F 7138 S - Page 24

Miele F 7138 S
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Repairs to electrical appliances
should only be carried out by a suit
-
ably qualified and competent person
in accordance with local and na
-
tional safety regulations. Unauthor
-
ised repairs could be dangerous.
The following can be corrected without
contacting the Miele Service Depart
-
ment:
What to do if . . .
. . . strange noises can be heard after
switching on the appliance, espe-
cially after it has just been installed.
^ Check to see whether any pieces of
furniture next to the appliance are vi-
brating whilst the appliance is in op-
eration.
Switch the appliance off then:
^ Check whether the appliance is
aligned correctly.
^
Check whether all parts at the rear of
the appliance are free from hin
-
drance. Remove any hindrance.
^
Check whether the cable clips were
unclipped from the back of the appli
-
ance before installation. They could
vibrate when the appliance is operat
-
ing.
^
Are all removable parts securely lo
-
cated in the appliance?
Remember that the noise of the com
-
pressor and the coolant circulating in
the system is unavoidable.
. . . the appliance does not get cool.
^
Make sure the temperature selector is
not set at "0".
^
Check that the plug is correctly in
-
serted in the socket.
^
Check that the fuse is not defective
and that the mains fuse has not
blown. If it has contact the Miele Ser
-
vice Department.
. . . the door will not open because it
has been opened and closed too
many times in succession.
This is not a fault. The suction caused
by opening and closing the door is pre-
venting the door from opening. Wait a
few minutes and then try again. It
should now open without force.
. . . the temperature is too low.
^ Turn the temperature dial to a setting
closer to "0".
^
The super freeze function has not
been switched off. The indicator light
is still on.
. . . the appliance is switching in too
frequently and for too long.
^
Check whether ventilation gaps have
been covered over or become too
dusty.
^
Check whether, the metal grille (heat
exchanger) at the rear of the appli
-
ance has become too dusty.
^
Has the door been opened too fre
-
quently, or large amounts of fresh
food have been put in at once for
freezing.
Problem solving guide
24