Problem Possible cause Remedy
The In-operation
indicator is flashing
quickly.
The buzzer is sounding.
All the programme
indicators flash when
the door is open.
Fault code FXX shows
in the display.
There may be a
technical fault.
–
Clean the water inlet filter
and clean the drain pump
and non-return valve as
described in "Maintenance".
If this does not resolve the
problem,
–
switch the dishwasher off
with the Off button V.
After a few seconds:
–
Switch the dishwasher on.
–
Select the programme
required with the
programme selector button.
– Close the door.
If the indicator lights flash
again, there is a technical
fault.
– Call the Service
Department.
The drain pump works
even when the door is
open.
Fault F70:
The Waterproof
System has reacted.
– Close the stopcock.
– Call the Service
Department.
Problem solving guide
52
To Next Page
