Miele G 646 SCi - Water and Drainage Issues

Problem Possible cause Remedy
The indicator light "In
-
let/Drain" is flashing and
the programme does not
continue.
Before rectifying the prob
-
lem you must:
–
Turn the programme
selector to the "Stop"
position.
–
Switch the dishwasher
off using the "On/Off"
button.
Water intake is restricted.
–
Open the stopcock
fully.
–
Check the water inlet
filter and clean if nec
-
essary, see "Cleaning
the water inlet filter".
– The water pressure at
the intake is lower than
0.3 bar. Seek profes-
sional advice.
Water outlet is restricted,
water remains in the wash
cabinet at the end of a
programme.
– Clean the filter combi-
nation, see "Cleaning
and Care".
– Clean the drain pump,
see "Cleaning the drain
pump and non-return
valve".
–
Clean the non-return
valve, see "Cleaning
the drain pump and
non-return valve".
–
Remove any kink in the
drain hose.
Problem solving guide
45