Rear screw feet
^ Use a TORX T20 screwdriver to ad-
just the rear screw feet
to the re-
quired height.
Higher = turn clockwise
Lower = turn anti-clockwise
Several turns are needed to adjust
1 mm in height.
Front screw feet
^ Adjust the front screw feet
manually
or with a flat blade screwdriver.
Now adjust the feet until the seal on
the top of the dishwasher is right up
against the underside of the
worktop, to which it will be screwed
later. Ensure that the dishwasher
stands level.
Installation
11
To Next Page
Loading...
