Connection to the water inlet
,
Water in the dishwasher must
not be used as drinking water.
–
The dishwasher may be connected
to a cold or hot water supply, max.
60 °C. When connected to a hot wa
-
ter supply all programme stages
which would otherwise be carried out
with cold water (pre-wash and in
-
terim rinse) as well as the Pre-wash
programme will be carried out with
hot water.
On models with recirculation conden
-
sation drying please note that if your
dishwasher is connected to a hot wa-
ter supply drying results may be im-
paired.
– The inlet hose is approx. 1.5 m long;
a longer hose (4 m), or a 1.5 m long
flexible metal hose tested to with-
stand pressure of 140 bar may be
bought from the Miele Spare Parts
Dept.
–
A stopcock with a 3/4 " male thread
must be provided on site.
–
The dishwasher is constructed to
comply with DVGW regulations, and
may be connected to a suitable sup
-
ply without an extra non-return valve
if national regulations allow this.
–
The water pressure (flow pressure at
the take-off point) must be between
0.3 and 10 bar.
If the water pressure is too low the
Water "inlet" or "inlet / drain" light (de
-
pending on model) may light up,
(see "Problem solving guide" in the
Operating Instruction booklet).
If the water pressure is too high, a
pressure reducer valve must be fit
-
ted.
,
The water inlet hose must not be
shortened or damaged in any way,
(see illustration).
If the stopcock is situated in the work
-
top, a special angle connector can be
ordered from the Miele Spare Parts
Dept. (Part No. 04 274 820).
Plumbing
22
To Next Page
Loading...
