This dishwasher is specially designed
for integration under a worktop run in a
fitted kitchen.
–
The front of the dishwasher is de
-
signed to take a front panel. It can be
fitted with a base unit door front to
match the rest of the kitchen.
–
The dishwasher does not have a
plinth facia. The plinth area of the
dishwasher needs to be covered ei
-
ther with a plinth facing to match the
kitchen furniture or with one which
can be ordered as a special acces
-
sory. The separate plinth facia can
be height adjusted to suit the
kitchen. The plinth return is freely ad-
justable.
Instructions for installing the dish-
washer are described in the following
sections.
,
To ensure stability, these dish-
washers must only be installed un-
der a continuous worktop which
must be securely screwed to neigh
-
bouring units.
,
The dishwasher must not be in
-
stalled under a hob. The high radi
-
ant temperatures which are some
-
times generated by a hob could
damage the dishwasher.
Opening the door
^ Hold one corner of the upper fixing
bracket and pull towards you (small
arrow).
Opening the door when the fixing
bracket has been taken off:
^
Insert your finger into the T-shaped
opening in the door opener and pull
the door open.
Installation
4
To Next Page
Loading...
