Miele G 653 - Page 8

Granite or marble worktops:
Worktops made from hard materials
such as granite or marble do not need
the cover plate for protection. The
cover plate is only used as a guide for
marking the position for the reflector
panel plastic holder.
Keep the cover plate in case the dish
-
washer is ever fitted under another type
of worktop.
^
First, remove the protective foil cover
-
ing the plastic holder for the reflector
panel and then take the holder out of
the cover plate.
^
Align the cover plate to the front
edge of the worktop in the middle of
the niche. Draw around the cut-out
for the plastic holder.
If the worktop has a very rounded
edge, pull the cover plate further for
-
ward so that the reflector panel is vis
-
ible later.
^
Stick the doublesided adhesive strip
supplied onto the back of the plastic
holder.
^ Remove the protective foil from the
adhesive strip and stick the holder to
the underside of the worktop at the
marked position.
^
Press the reflector panel into the
plastic holder.
Installation
8