EasyManuals Logo

Miele G 7881 Operating Instructions

Miele G 7881
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
In order to achieve good cleaning
results, the washer-disinfector needs to
operate with soft water. Hard water
results in the build-up of calcium
deposits on instruments etc. and in the
washer-disinfector.
Mains water with a hardness level
higher than 0.7 mmol/l (4° d German
scale) needs to be softened. This takes
place automatically in the integrated
water softener.
The water softener requires
reactivation salt.
The washer-disinfector must be
programmed to correspond to the
water hardness in your area.
Your local water authority will be able
to advise you on the water hardness
in your area.
Where the water hardness fluctuates
e.g. between 1.4 - 3.1 mmol/l (8 - 17 °d
German scale) always programme the
washer-disinfector to the higher value
(3.1 mmol/l in this example).
The built-in water softener has
settings from 1 °d - 60 °d (0.2 -
10.8 mmol/l).
In the event of a fault, it will help the
service technician if you know the
hardness of your local water supply.
Enter the water hardness below:
°d / mmol/l
Programming the water
softener
^
Switch off the machine.
^
Turn the programme selector to f.
^
Press ß and 6 at the same time,
hold them in and, whilst doing so,
switch the machine on with the I-0
switch.
The current programme status P.... will
appear in the display.
The indicator light p / 6 will come on.
^
Press 0 once.
E01 will appear in the display.
^ Turn the programme selector one
switch position clockwise (1 o'clock
position).
The number 19 will appear in the
display (the factory water hardness
default setting in °d, equivalent to
3.4 mmol/l).
^ Press ß as many times as
necessary, or hold it in until the
required value (degree of hardness
in °d) appears in the display.
See table on the next page for water
hardness settings in °d, mmol/l and °f.
Once the number 60 has been
reached, the counter will begin again at
0.
^
Press 6.
SP will appear in the display.
^
Press 6 again.
The setting will now be stored in
memory. The display will clear.
The machine is now ready for use.
Water softener
15

Table of Contents

Other manuals for Miele G 7881

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miele G 7881 and is the answer not in the manual?

Miele G 7881 Specifications

General IconGeneral
BrandMiele
ModelG 7881
CategoryWasher
LanguageEnglish

Related product manuals