Switching on
^
Close the door.
^
Open the stopcock.
^
Press the I-0 switch.
When the programme selector is at f,
a point lights up in the display.
Starting a programme
Choose your programme according to
the type of instruments or utensils being
cleaned and the degree of soiling. The
different programmes and their uses
are described in the Programme chart
at the end of this booklet.
^
Turn the programme selector
clockwise or anti-clockwise to the
required programme.
The temperature of the first stage of the
programme selected will appear in the
display, except with D and 6.
The indicator light next to the 6 button
will flash.
Selecting the Drying 0 additional
function
The Drying additional function may be
selected immediately after the
programme has been selected (except
with Pre-rinse D and Drain 6).
To do this:
^ Press 0.
The drying phase operates with pulsed
heating for ten minutes. The total
running time of the programme
lengthens accordingly.
^
Press the Start 6 button.
The current temperature will appear in
the display.
The indicator light next to the Start 6
button will light up.
Once the programme is running, all the
other programmes are blocked.
If the programme selector is then
turned to another programme, the
values shown in the display will go out.
The values can be seen again if the
programme selector is turned back to
the position of the programme currently
in operation.
Operation
31
To Next Page
Loading...
Need help?
General
