Buzzer
A buzzer can be programmed for the following:
– a constant tone will sound at the end of a programme,
– a buzzer will sound at one second intervals as a fault warning, and
– 3 short beeps followed by a 2 second pause, then 3 short beeps etc will sound
as a reminder to remove a test item.
The reminder to remove a test item function has to be programmed by a Miele
service technician or an authorised and trained Miele Service Dealer.
The buzzer settings are displayed as numbers:
20 Switched off
21 At the end of a programme (factory default setting)
22 Fault indication
23 At end of a programme + fault indication
24 Reminder to remove a test item
25 At the end of a programme + reminder to remove a test item
26 Fault indication + reminder to remove a test item
27 At the end of programme + fault indication + reminder to remove a test item.
Step Display / Result
^ Press 0 until E04 appears.
E04
^ Turn the programme selector to E.
21
^
Press ß repeatedly or hold pressed in until the
required number appears in the display, e.g. 26.
26
Value set:
The buzzer will sound at the setting selected for 30 seconds.
To switch the buzzer off early:
–
turn the programme selector to f,
–
press ß.
–
interrupt the electricity supply, e.g. open the door.
Programmable functions
37
To Next Page
Loading...
Need help?
General
