Changing programme parameters
The parameters for programmes A, E and Vario TD can be changed to suit
particular requirements. To do this the temperature and the temperature holding
time in the Main wash 1 and Final rinse 2 programme blocks can be changed.
The programme chart at the end of these instructions shows the factory default
settings for the temperature and temperature holding time of the individual
programme blocks.
Please make a note of any changes in the appropriate section of the programme
chart.
The programme parameters in the Main wash 1 programme block of the
SPECIAL 93°C-10' programme cannot be changed.
Values which can be set for the temperature:
– 30 °C - 93 °C in the A and vario TD programmes,
– 30°C-70°Cin theE programme.
Temperatures above 55° C cause blood denaturation and possibly fixation.
In the "vario TD" programme the requirements for the appropriate infection
prophylaxis must be observed.
Values which can be set for the temperature holding time:
–
1-15 minutes.
Changing the temperature
Step Display / Result
^
Press button 0 repeatedly or hold pressed in until
the level of the programme block you wish to change
appears in the display.
E09 for Main wash 1
E25 for Final rinse 2
^
Turn the programme selector to the programme you
wish to change, e.g. E.
°C ~65
^
Press ß or hold pressed in until the required value
appears in the display, e.g. 70 °C
°C ~70
Programmable functions
38
To Next Page
Loading...
Need help?
General
