Discoloration of the ironing cover
A slight to heavily brown coloration of the iro-
ning cover is normal.
To avoid the cover from turning black:
– Always use the complete roller width.
– Space out smaller items, alternating from
left to right.
– Raise the heater plate and lower the tem-
perature during breaks.
Washing the ironing cover
The ironing cover should not be washed if
only slightly discolored (yellowing normal).
^ A heavily soiled cover can be washed at a
hot temperature 203°F (95°C), spun and
returned to the roller while still damp.
^ Before removing the ironing cover to clean
or replace it, turn the rotary iron off, let the
heater plate cool and remove the feed
board.
^ Unhook the laundry pick-off units off the
roller one after another.
^ Turn the rotary iron on "I" and raise the
heater plate "P".
^ Press the foot pipe to the 2nd switch point
and remove the ironing cover while the
roller turns backwards.
Applying an ironing cover
^ Raise the heater plate and turn the rotary
iron off.
^ Lay the ironing cover on the roller
(parallel).
^ Turn the rotary iron on "I" and lower the
heater plate "O". The ironing cover is
pulled in.
^ Steel wool bits will fall on the ironing table
when removing or replacing the ironing
cover. Clean them immediately.
A repadding is necessary if an air gap is vi-
sible between the lower edge of the heater
plate and the roller (laundry outlet).
To replace or renew the roller padding call
Technical Service.
Laundry pick-off unit
Clean the tips of the laundry pick-off unit’s to
remove dirt and starch every 2-3 months or
as needed.
^ Pull the laundry unit out and clean with
warm water.
Maintenance
Call Technical Service for the following
maintenance.
^ When the roller needs repadding, check
and grease the swivel joints.
^ Check and replace the carbon brushes.
Cleaning and Care
12
To Next Page
Loading...
