Before building the appliance in, you
will need to decide on which side the
door is to be hinged. If left hand door
hinging is required, follow the
instructions below.
To change the door hinging you will
need the following tools:
–
a flat-bladed screwdriver,
–
a selection of Torx
®
screwdrivers:
Torx
®
15, 20, 25.
Appliance door
^
Open the door.
^ Remove covers a, b and c with a
screwdriver.
^
Loosen fixing screws d slightly.
^
Slide the door outwards, lift it off e
and place it to one side.
^
Now remove fixing screws d and
screw them loosely into position at the
top and the bottom of the opposite side
ef.
Use a power screwdriver to secure
the hinges - the screws are
self-tapping.
Changing the door hinging
39
To Next Page
Loading...
Need help?
General
