Installing the appliance
55
Whilst counterholding adjusting
bolts with a screwdriver, tighten
nuts on the appliance door with
screwdriver.
Attach the appliance door and the
furniture door using screws through
fixing brackets:
– Drill holes in the furniture door (mark
the position of the holes first).
– Screw in the short chipboard
screws (4 x 14mm).
Align depth "Z"on the furniture door:
Loosen the screws in the long slots at
the top and bottom of the door.
By moving the furniture door, create a
gap of 2 mm between the furniture
door and the front edge of the niche.
Align it to match the adjoining
furniture doors.
Close the door and align it with
adjoining furniture doors.
Tighten all screws again.
To Next Page
Loading...
Need help?
General
