Technical Information
35
KF 18xx/19xx
Service programming settings
Symbol Function Options Factory setting
b
Button sounds on/off
b0: Button sound off
On (b1)
b1: Button sound on
n
Demo mode on/off
n0: Demo mode off
Off (n0)
n1: Demo mode on
h
Filters
h0: Filter is installed in appliance
---
h1: Filter is not installed
h2: Filter replacement confirmation.
Touch the thermometer
to confirm.
H
SmartFresh
temperature
H1: 32.9°F (0.5°C)
34.7°F (H3)
H2: 33.8°F (1.0°C)
H3: 34.7°F (1.5°C)
H4: 35.6°F (2.0°C)
H5: 36.5°F (2.5°C)
Table 030-19: Service Programming Settings
4.3 Service Mode
1. Turn on the appliance.
2. Touch the thermometer
.
3. Touch the refrigerator icon
to access the refrigerator or the freezer icon
to access the freezer.
4. Note the position of the down arrow
. (If the current temperature setting
is at the minimal setting, then this icon will not be lit. Touch the up arrow
to raise the temperature and to make the down arrow visible.)
5. Touch the thermometer
to turn off the display.
6. Press and hold in the area of the down arrow
.
7. Touch the thermometer
once.
8. Release the down arrow
, then touch it again 3 times; hold on the 3rd
time until S is displayed.
9. Scroll through, using the arrows, to the desired function (e.g., F). See
Table 030-20 for a list of functions. Touch the thermometer
to access
the options for that function. For example, if F was selected, F – will be
displayed after the thermometer is touched.
10. Scroll through to the desired option. If an option is flashing, then it can be
selected. If it is lit steadily, then it has been programmed. See Table 030-
20 for a list of options for each function.
11. Touch the thermometer
to save the option. It will now be steadily lit.
12. Scroll through to – (e.g., F –).
13. Touch the thermometer
to exit to the list of functions. F (as an example)
will now be displayed. Scroll to other functions to make changes, or scroll
back to S and then touch the thermometer
to quit.
14. To quit without saving any changes, close the appliance door or do not
touch any icons for 2 minutes.
To Next Page
Loading...
Need help?
General
