Granite and marble worktops
Preparing the worktop cut-out
a Worktop
b Cooktop
c Gap
As the ceramic glass and the
worktop cut-out have a certain
dimensional tolerance, gap c (min. 1
mm) can vary.
^ Make the worktop cut-out as shown
in "Building-in dimensions".
Remember to maintain a minimum
safety distance (see "Safety
clearances").
Connecting the mains connection
cable to the appliance
The mains connection cable must
be connected by a suitably qualified
and competent electrician in
accordance with current local and
national safety regulations.
^
Connect the mains connection to the
appliance according to the wiring
diagram (see "Electrical connection")
Installing the cooktop
^ Feed the mains connection cable
down through the cut-out.
^ Centre the cooktop b in the cut-out.
^ Connect the cooktop to the mains.
^ Check that the cooktop works.
^ Seal the remaining gap c with a
silicone sealant that is heat-resistant
to at least 160 °C.
For granite and marble worktops,
only use silicone sealant that is
specially formulated for granite and
marble, and observe the sealant
manufacturer's instructions.
Installation
53
To Next Page
Loading...
Need help?
General
