Miele T 8843 C User Manual

Problem Possible cause Remedy
The following
flashes at the
end of a
programme:
—œ–...C~–...Cœ˜...
The programme has finished
but the laundry is still cooling
down.
You can remove the laundry
and spread it out to allow the
heat to dissipate, or leave it in
the dryer to cool down more.
The Clean out
airways
indicator light
comes on.
The dryer is not working
efficiently or economically.
Possible cause: Blockages
due to fluff or detergent
residues.
–
Cleaning the filters is
usually all that is required.
However, if the message
does not go out after you
have cleaned the filters,
then also check all the
possible causes described
under "The drying process
goes on too long or even
switches off".
To delete the message:
– Open and close the door
while the dryer is switched
on.
The Clean out airways
indicator light can be
deactivated (see
"Programmable functions").
The programme
is cancelled.
The Clean out
airways
indicator light
comes on.
The buzzer
sounds.
See above for possible
causes and their remedies.
To delete the fault message:
–
Open and close the door
while the dryer is switched
on.
–
Start a programme.
–
If this warning appears
again, contact Miele.
The Empty out
container
indicator light
comes on.
The buzzer
sounds.
The condensed water
container is full or there is a
kink in the drain hose.
–
Empty out the condensed
water container.
–
Check the drain hose.
To delete the message:
–
Open and close the door
while the dryer is switched
on.
Problem solving guide
34

Miele T 8843 C Specifications

General

Brand	Miele
Model	T 8843 C
Category	Dryer
Language	English