Problem Possible cause Remedy
Water leaks from the
machine after the
condenser unit has
been cleaned.
–
The inner cover of the
condenser unit has not
been locked properly
and/or the condenser
unit has not been
positioned correctly.
–
There is a build-up of
fluff.
–
Ensure that the
condenser unit is
positioned correctly
and lock the inner
cover.
–
Check the rubber
seals.
–
Use a cloth to remove
any visible fluff from the
inside of the condenser
unit housing.
A programme cannot be
started.
There is no immediate
cause.
–
Is the dryer switched
on?
– Is the mains plug
plugged in?
– Is the door closed
properly?
– Has the fuse or circuit
breaker tripped?
Power cut. When power is restored to the dryer after a power
cut, the programme will continue as long as the
cooling down phase had not been reached.
The interior drum
lighting does not come
on.
The lighting switches off
automatically (to save
energy).
–
Switch the dryer off
and then on again.
–
If the lamp needs to be
replaced, follow the
instructions: Refer to
the following:
Problem solving guide
38
To Next Page
Loading...
Need help?
General
