Cleaning and care
65
Tip: To speed up the removal of residue
from the surface, run a water jet vertic-
ally over the front of the plinth filter.
Squeeze the plinth filter very carefully
several times as you rinse it.
Rinse the entire plinth filter thoroughly
until all visible residue has been re-
moved.
Continue to carefully squeeze the
plinth filter until all of the water has
been removed.
Tip: To soak up water, place the damp
plinth filter between 2hand towels. On
an even surface, gently press down on
the plinth filter with the back of your
hand. This will dry the plinth filter more
quickly.
The plinth filter must not be fitted
dripping wet.
Otherwise, this could cause a fault.
Carefully squeeze the water out of
the plinth filter.
If a drying programme is interrupted
with a fault message after the clean
plinth filter has been fitted, the plinth
filter was too wet when it was fitted.
Carefully squeeze the water out of the
plinth filter again. Leave the plinth filter
to air-dry.
If a fault occurs again despite this, it
may be caused by stubborn residue
from washing substances. Reactivate
the plinth filter in the washing ma-
chine. See “Problem solving guide –
Reactivating the plinth filter”.
Blockages caused by a dam-
aged or worn filter.
The heat exchanger becomes
blocked and damage may occur.
Check the plinth filter following the
instructions provided in “Problem
solving guide – Replacing the plinth
filter”. Replace the plinth filter if ne-
cessary.
Use a damp cloth to remove any fluff
from the handle.
Fit the plinth filter back on the handle.
Make sure it is the correct way round.
To Next Page
Loading...
Need help?
General
