Spinning
29
To omit the final spin (Rinse
hold)
Touch the sensor (rinse hold).
The laundry is not spun after the final
rinse and remains in the final rinse wa-
ter. This helps prevent creasing if the
laundry is not going to be removed from
the drum immediately after the end of
the programme.
After the end of a programme
The sensor for the optimum spin
speed lights up in the control panel.
You can change the spin speed. The
Start/Stop sensor lights up, flashing.
Start the final spin:
touch the flashing Start/Stop sensor
once.
The final spin is carried out.
End the programme:
touch the flashing Start/Stopsensor
twice.
The water will drain away.
To omit rinse and interim spin
and the final spin
Touch the sensor.
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch in.
In some programmes an additional rinse
is introduced with this setting.
To Next Page
Loading...
Need help?
General