Mifa WILDROCK - Page 12

FAQ
疑难解答
使⽤话筒信号不好或有卡顿时 可通过短按"+"或“-”，选择合适的 ： 获取最佳效果频段 CH01~CH10，以
话筒不能与主机连接时
话筒在开机状态下，同时按住“电源键”和“-”屏上显⽰DE，恢复默认设置重新与主机连接
话筒⽆法开机 请插上充电线充电激活
故障
Problems
解决⽅法
Howtosolve
标配话筒遗失或坏掉了，新配的话筒
如何与⾳箱配对ID？
⾳箱关机，话筒开机，同时⻓按话筒的“电源键”和“+”键，屏显⽰ID符号，进⼊对ID状态。
此时⾳箱⽴即开机即可⾃动配对ID。（连接成功后，⾳箱会有连接成功提⽰⾳）
如何清除话筒的ID？
话筒:开机状态，同时按电源键和“-”键，屏显⽰DE符号，这时话筒返回到⽆ID状态。
注意：如果话筒清除了ID，需要再次与⾳箱连接时，按新配的话筒⽅法重新配对ID。
Whenthesignalofthemicrophoneisnot
goodorisstuck,
Shortpress“+””-”toselecttheappropriatefrequencybandfromCH01-CH10.
Whenthemicrophonecannotbe
connectedtothehost
Ifthemicrophonecannotbeturnedon
pleasepluginthechargingcabletochargeandactivate;
Pressandholdthe“”and“-”simultaneouslyinthepower-onstate,then“DE”
willbedisplayedonthescreen,itwillrestoretothedefaultsettingsandreconnect.
Howtopairwithanewmicrophone?
Whilethespeakerinpower-offstate,microphoneinpower-onstate,pressandholdthe
“”and"+"buttonofthemicrophonesimultaneously,thescreenwilldisplaythe
“ID“andentertheIDparingstatus.
Atthistime,thespeakercanbeautomaticallypairedwiththeIDwhenitisturnedon.
(Aftertheconnectionissuccessful,thespeakerwillhaveabeep).
Note:IfthemicrophonehascleareditsIDandneedstobeconnectedtothespeakeragain,
re-pairtheIDaccordingtothemethodofthenewmicrophone.
Microphone:Pressthe“”and“-”simultaneouslyinthepower-onstate,then
“DE”willbedisplayedonthescreen,itwillrestoretononIDstatus.
HowtocleartheIDofthemicrophone?