ENG
2
Pairing Your SIMPL GO Bluetooth Headphones
1: Make sure your SIMPL GOs are charged and turned OFF.
2: Press and hold the M-button on the headphones
for 5 seconds until the indicator light flashes Red and Blue alternatively
(pairing mode).
3: Activate Bluetooth on your phone or other device and search for Bluetooth
devices and select SIMPL GO by MIIEGO.
Charging Your MIIEGO® Headphones
When the Red light is on, the headphones are charging.
When the Red light is off, the headphones are fully charged.
Full charging time is around 2-3 hours.
Next time charging
When the LED indicator light is flashing every 5 seconds, the battery status
is low and needs charging.
You will then also hear a battery warning tone every 180 seconds.
Turning Your MIIEGO® Headphones On and Off
ON: Press the M-Button for 3 seconds until the indicator light flashes Blue
3 times.
OFF: Press the M-Button until the indicator light flashes Red 2 times.
Activate Siri on iOS-device: Double press Volume-down button (work only
In STANDBY mode).
Perform Soft Reset: During charging, press and hold M-button and
Volume-up button for 5 seconds.
This device contains a lithium accumulator.
Improper use can cause overheating and fire.
Only listen to music in a moderate volume and
in moderate periods of time. Excessive exposure
to high sound levels can lead to noise-induced
hearing loss.
To Next Page
Loading...
