Manual LOGO 690SX - ©Mikado Model Helicopters GmbH - Page 7
1x M3x47
2x
3x5x1,2
4x
M2,5x10
12x 2,2x13
2x M2x10
1x M2x12
4x
9x M2
3x M2,5x35
2,2x13 (4x)
26 mm
(4x)
2,2x13
(4x)
M2,5x10 (4x)
1
3
4
5
6
7
8
9
5 Servo Installation
Bag 1 • Bag 9
Bag 9
Bag 1
Bag 1
Apply a small amount
of oil to the rotor shaft.
If you are installing Futaba servos, add the
distance plate for the two aileron servos.
Aileron left Aileron right
Elevator
Rudder
LOGO Rotor Head (V-Stabi, ybarless head)
16 mm 16 mm 16 mm
14-16mm
Attach the ball links so that the engra-
ved number is on the outer surface
pointing towards you.
Using the two spacer washers (3x5x1.2 ), you can adjust the tting of the canopy. Without
the washers, the edges will overlap. If washers are used, edges are touching slightly.
To Next Page
Loading...
