Need help?Do you have a question about the mikroElektronika EasyPIC v7 and is the answer not in the manual?
General| Brand | mikroElektronika |
|---|---|
| Model | EasyPIC v7 |
| Category | Motherboard |
| Language | English |
Explains the powerful built-in programmer and debugger supporting many MCUs.
Describes support for both 3.3V and 5V microcontrollers, increasing versatility.
Explains the board's switching power supply and dual voltage regulators.
Step-by-step guide to powering the board using a USB cable.
Instructions for powering the board with an external adapter connector.
Guide for connecting power via screw terminals from a lab supply.
Instructions to align microcontroller pins correctly with the DIP socket.
Guidance on applying even force to insert the microcontroller into the socket.
Explains the initial steps to start using the programmer and board.
Guides on setting jumpers for MCLR pin selection and programming lines.
Guides through the four steps to successfully install the necessary drivers.
Comprehensive guide for installing the mikroProg Suite software.
Details the 6-step process for installing the programming software.
Guides on how to use the debugger interface and features within the compiler.
Details how to enable USB communication via PORTA or PORTC.
Guides on connecting the DS1820 sensor using jumpers and pins.
Guides on connecting the LM35 sensor using jumpers and pins.
Instructions for connecting potentiometers to simulate analog inputs using jumpers.
To Next Page