Global Default Setting
The STA unit may be set to a global default by pressing the volume button during
power-up. This sets the device to the following:
1. STA Mode is “ON” and set to tones.
2. AutoPurge/Retract is set to “ON”.
3. Aspiration is set to “ON”.
4. The device will use tones to indicate the various flow rates. .
5. The device will chime when the cartridge is empty, ¼, ½, and ¾ full.
6. The audible volume set at the midpoint.
7. The Cruise Control is enabled.
8. The Multi-Cartridge feature is set to “OFF”.
9. The STA will automatically notify you when to lubricate the O-ring and
plunger.
Features 1-6 may also be programmed by holding down the Select button while
the unit is turned on. The Select button must be held down thorough the entire
setting. When released, the feature settings changes are saved.
The STA button is use to toggle between the STA tone mode and STA numeric
mode. In the numeric mode, the STA “reports” the actual pressures “read” during
the injection. For example, if the numeric mode was selected, the STA will
provide the actual pressure in addition to the LED and audible indicators. If the
tone mode was selected, the device will provide the ascending triple tone.
- 25 -
To Next Page
Loading...
