Millenium slow stick x - Setup and Flight Preparation; Control Throws Setup; First Flight Recommendations

To Previous Page

Main Wing Decal (not included in “short kit”)

1. Cut excess material from decal before removing the

backing.

2. Remove the protective backing to expose the

adhesive.

3. Add about 3 drops of dish soap to 2 pints of clean

water. Put it in a spray bottle and spray the back of

the decal.

4. Slide the decal into position and squeegee the excess

water from under the decal.

5. Allow the decal to dry overnight.

First flight: Be sure all controls are set correctly. Take-

off should be at half throttle with recommended power

plant. Climb to a higher altitude and adjust trims as

needed. When landing, be sure to land softly, as the

original GWS landing gear is not extremely rigid. You

should find that this aircraft has a very low stall rate and

is capable of most acrobatics. Happy flying!

Enjoy Your New Millennium R/C

Slow Stick X or X-Trainer!

If you should find a part missing or damaged, or have

any questions about assembly, please contact us at the

address below:

Millennium R/C

12859 Lower River Blvd. Orlando, FL 32828

Phone: 407-208-9745

Fax: 866-799-2372

E-mail: Service@millenniumrc.com

For updates and tips, visit the

Slow Stick X or X-Trainer Build Thread on RC Groups:

Other manuals for Millenium slow stick x