EasyManuals Logo

Millenium slow stick x Assembly Manual

Millenium slow stick x
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
List of Provided “Short Kit” Parts:
All laser-cut balsa and plywood parts needed to
complete the wing/tail sections.
Disclaimer:
Millennium R/C assumes no
responsibility for any accident or injury
to persons or damage to property.
Additional Items Required:
1. GWS Slow Stick Electric ARF Park Flyer Airplane
Kit (used or new)
2. All tools, equipment and materials recommended in
GWS Slow Stick Assembly Instruction Manual
3. One or two mini servos for ailerons and hardware for
aileron linkage
4. .047 Piano wire for aileron pushrods
5. 5/32” aluminum tubing for rubber band post
extenders
6. Cyanoacrylate or CA Glue (thin and thick)
7. Hobby knife
8. 80-grit and 100-grit sandpaper
9. Sanding block
10. Hinge tape (recommend 3M Scotch ¾”
Transparent Tape)
11. Tape measure and/or yardstick
12. Square
13. Razor saw
14. A park-flyer type lightweight plastic covering (Ex:
Ultracote Lite ™) and any tools recommended in its
instructions for application
15. Recommended Motor and speed control (400 style
outrunner, 125-200 watts with 20 amp speed control,
or equivalent)
16. Battery and Propeller (use what is recommended in
instructions for motor)
17. #33 Rubber Bands
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
The Slow Stick X and the X-Trainer are also
available as a Build Kit Bundle (complete kit)
which includes the following additional items
at an additional charge:
1. Slow Stick X Decal or X-Trainer Decal
2. Fuselage Set which includes 10mm square carbon
fiber fuselage, pushrod wire, Velcro strap to mount
battery, foam tape for mounting receiver, servo
mount, battery mount, wing mounts, adjustable
pushrod guide, steerable tail gear and necessary
screws/hardware for these parts
3. Millennium R/C outrunner motor mount
4. X-Gear carbon fiber landing gear
5. 2 2 ½” foam wheels
6. 2 #2 washers
7. 2 #2-1/4 sheet metal screws (optional for motor
mount)
8. 2 #2-3/8” sheet metal screws
9. 4 control horns
10. #33 Rubber bands
Slow Stick X or X-Trainer Wing/Tail Build Kit Assembly Instructions Rev. 12

Other manuals for Millenium slow stick x

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Millenium slow stick x and is the answer not in the manual?

Millenium slow stick x Specifications

General IconGeneral
BrandMillenium
Modelslow stick x
CategoryToy
LanguageEnglish