7
Figure 17 (SSX)
Figure 17 (X-Trainer)
Figure 18 (SSX)
Figure 18 (X-Trainer)
19. Join tail surface pieces as shown in Fig. 19.
Figure 19
20. Sand all tail surfaces, round all edges, and taper
leading edges of all control surfaces, including
ailerons. (Fig. 20) Cover with light model covering.
Assembly of the control hinges
Hinges are made from hinge tape or 3M Clear
Cellophane Tape. The hinge cross-section is shown in
Fig. 20. Hinges are done after covering.
Figure 20
Final Build Kit Assembly
1. Tape a length of Scotch tape™ along the rear trailing
edge of the horizontal stabilizer and secure with your
finger (either side is fine). Now, flip the stabilizer and
place on a work surface. See diagram below:
To Next Page
Loading...