Millennia Media NSEQ-2 Quick Start Guide

060414

page 1 of 2

Millennia

NSEQ-2 Quick Start Guide

NSEQ-2 Front Panel

1. Band In/Out Switch "IN" — places its associated EQ

band in circuit or out of circuit

2. Frequency Select Switch — selects fixed high and low

band frequencies

3. Peak/Shelf Select — When LED is on, EQ is shelving at

6 dB per octave. When LED is off, EQ is peaking with a

fixed "Q" of 1.0.

4. Boost/Cut Control — +18 dB of boost and -18 dB of

cut. Boost/Cut potentiometer has 21 detented positions

for accurate repeatability and session logging.

5. Parametric Frequency Control – selects EQ center

frequency.

6. Parametric Frequency Range Select Switch "10X"

—When LED is on, frequencies as shown on front panel

legend are multiplied by 10X. When LED is off,

frequencies are as shown on front panel legend.

7. Parametric Q Control – EQ bandwidth.

8. Master Equalizer In/Out Select Switch — "EQ IN"

places EQ in the signal path. Hardwired relay bypass

when out.

9. Twin Topology — Select J-FET (LED illuminated) or

Vacuum Tube circuitry.

10. Gain Range — +/- 18dB or +/- 9dB

11. Power Indicator — when illuminated shows the NSEQ-

4 is powered up and active.

12. Power Switch — turns power on and off.

GROUND LIFT

PUSH PUSH

115

IN 2

OUT 2

IN 1

OUT 1

NSEQ-2 Rear Panel

1. Inputs — In 1 (Left), In 2 (Right) Conventional 3-pin female

XLR input jacks for all balanced or unbalanced line level signals..

2. Outputs — Out 1 (Left), Out 2 (Right) Conventional 3-pin

male XLR output jacks.

3. Earth/Audio Ground Jumper — A barrier terminal which ties

earth ground to audio ground. If ground "hum" loops are

experienced when using the NSEQ-4, removing this jumper may

help. Using this jumper, the integrity of the chassis/earth ground

connection is never compromised. Do not defeat the earth

grounding pin on the AC plug.

4. AC Voltage Mains Selection — The fuse block contains two

fuses; one fuse is in series with the hot power line while the other

fuse is in series with the neutral power line. Both fuses must be

installed.

To change the mains voltage selection, remove IEC power

connector and assure that the NSEQ-4 is not connected to mains

power. With a non-conductive tool, gently pry the fuse block away

from the power entry module. Slide out the internal PC Board,

turn it over, and reinsert the PCB so that the desired AC mains

voltage appears in the viewing window. Double check that the

fuses installed correspond to the AC mains voltage range which

appears in the viewing window. Gently push the fuse block back

until flush and snug.

Fuses: For 100-120 VAC mains, use two 5 x 20 mm, 1A, slow

blow, 250 V, Littelfuse 218 or equiv. For 200-240 VAC mains, use

two 5 x 20 mm, 1A, slow blow, 250 V, Littelfuse 218 or equiv.

5. Power Entry — IEC Power Receptacle for use with removable

cords. Use only the power cord provided. (Export units’ cords are

provided by the distributor.)

Media & Music Systems

Millennia NSEQ-2 - Page 12

Table of Contents

Other manuals for Millennia NSEQ-2