Milnor E-P Express - Table 5 Summary of Drain Type Choices

28
Pellerin Milnor Corporation
NOTICE: Selected drain type may change automatically—The controller requires that
the basket always accelerate to drain speed before advancing to extract speed, even if a
stop or bath-speed drain type is programmed.
• Standard and stop at fill drain types are valid for bath steps followed by any other type of
step.
• Two-way wash speed, do not drain, and stop at drain drain types will automatically change
to a standard drain when an extract is programmed as the next step.
• A stop at fill and drain drain type will automatically change to a stop at fill drain type when
an extract is programmed as the next step.
Table 5. Summary of Drain Type Choices
Drain
Type
Help Screen
Description
Basket Motion
Drain Valve
During Fill Phase During Drain Phase
0 Standard
set by Type of Step
decision for this step
standard drain speed opens after distribution
1
2-way wash
(see Note A
below)
set by Type of Step
decision for this step
reversing at wash
speed
opens after programmed
step time
2
Do not drain
(see Note A
below)
set by Type of Step
decision for this step
none—following bath
determines basket
rotation
does not open
3
Stop at fill
stopped until desired
level is achieved
rotates clockwise at
standard drain speed
opens after distribution
4
Stop at drain
(see Note A
below)
set by Type of Step
decision for this step
stopped
opens after programmed
step time
5
Stop fill & dr
(see Note A
below)
stopped until desired
level is achieved
stopped
opens after programmed
step time
6
RinSave
®
(see Note B
below)
set by Type of Step
decision for this step
advanced drain se-
quence (described
above)
opens 10-15 seconds
after bath time ends
Note
A:
This selection is not valid immediately before an extract step. Refer to the Notice above
this table for specifics.
Note
B:
This selection is available only when the machine is equipped and configured for this
option.
Display or Action Explanation
0
Standard drain speed—Basket turns clockwise at drain (distri-
bution) speed while draining. Standard drain speed varies by ma-
chine model, but is designed to impart about one G of
acceleration to the goods. Basket movement while filling is deter-
mined by the Type of step decision and the specific design of the
Programming