62
Pellerin Milnor Corporation
Table 19. E-P Express
®
Inputs
Display Code Input Name
Connector-Pin
A Door closed M6–1
B Low Water Level M6–9
C
Vibration switch tripped
M6–2
D
Input from Inverter
M6–10
E
High water level
M6–3
F
Keyswitch in Program position
M6–11
G not used M6–4
H Halt—external fault M6–12
I Halt—bath time M6–5
J
not used (Door open desired on MWR_
models with WUMWRXGG software)
M6–13
J
Door open desired
M6–13
K not used M6–6
L not used M6–14
4.2.4 Actuating Microprocessor Outputs
BNCJHT06.R03 0000209520 A.4 B.3 A.5 1/2/20 1:16 PM Released
Machine functions may be tested individually or in groups by using the Test Outputs component
of the Manual menu. The machine must be idle (not running a formula).
DANGER: Crushing and Entanglement Hazard — Bare manual outputs actuate
washer-extractor mechanisms. Keep all personnel clear.
Display or Action Explanation
Accesses the Manual menu.
MANUAL MENU
3 TEST OUTPUTS
This is the Manual menu display with the Test Outputs compo-
nent selected.
Accesses the output testing selection.
TEST OUTPUTS
01 INJECT CHEMICAL 5
This is the Output testing display.
Indexes forward and backward through the output names, as
shown in the table of outputs in this section.
TEST OUTPUTS
07 COLD WATER VALVE
Example display with output in place to be selected and subse-
quently actuated.
Accesses the selected output for actuation. All outputs are initially
disabled when accessed.
Troubleshooting
To Next Page
Loading...
