To Next PageTo Next Page
Need help?Do you have a question about the Milwaukee 2630-20 and is the answer not in the manual?
General| Voltage | 18V |
|---|---|
| Arbor Size | 5/8 inches |
| No Load RPM | 3, 500 RPM |
| Type | Circular Saw |
| Max. Cut Depth at 45 Degrees | 1-5/8 inches |
| Max. Cut Depth at 90 Degrees | 2-1/8 in |
| Battery Type | Lithium-Ion |
| Blade Diameter | 6-1/2 inches |
Keep area clean, avoid explosive atmospheres, keep bystanders away.
Use proper plugs, avoid wet conditions, don't abuse cords, use GFCI outdoors.
Stay alert, use PPE, prevent unintentional starts, remove tools.
Don't use if switch faulty, disconnect power, store properly, maintain tools.
Use designated battery packs, keep away from metal objects.
Keep hands away from blade, don't reach under workpiece, adjust depth, secure workpiece.
Sudden reaction to pinched blade, avoid by firm grip, proper positioning, and not forcing the tool.
Push release buttons to remove, slide to insert until it latches securely.
Use sharp, thin kerf blades, check speed rating, avoid abrasive wheels.
Check guard lever for free movement, spring action, and proper retraction/return.
Remove battery, place saw on side, remove bolt/flange, slide guard lever, remove blade.
Loosen lever, adjust shoe, ensure blade extends 1/8"-1/4" below material.
Ensure blade is 90 degrees to shoe using square and adjusting screw.
Clamp workpiece, align sight line, start saw, maintain firm grip, release trigger immediately if binding.
Blade not straight, binds, smokes, or turns blue from friction.
Support large panels to prevent binding and kickback, ensure proper depth.
Cutting across the grain, advance saw slowly to avoid splintering.
Cutting lengthwise, use rip fence for cuts, clamp lumber for wider cuts.
Regular maintenance, return for lubrication, inspection, testing.
Clean vents and handles, use mild soap and damp cloth, avoid solvents.
Return tool, battery, charger to nearest service center.
