Milwaukee WORK LIGHT - User Manual

WORK LIGHT
Compatible with MILWAUKEE V28 Lithium-Ion Battery Packs
LAMPE DE TRAVAIL
Compatible avec batterie Lithium-Ion V28 MILWAUKEE
LAMPARA DE TRABAJO
Compatible con baterías Iones de Litio de V28 de MILWAUKEE
Cat. No.
No de Cat.
49-24-0185
OPERATOR'S MANUAL
MANUEL de L'UTILISATEUR
MANUAL del OPERADOR
TO REDUCE THE RISK OF INJURY, USER MUST READ OPERATOR'S MANUAL.
AFIN DE RÉDUIRE LE RISQUE DE BLESSURES, L'UTILISATEUR DOIT LIRE LE
MANUEL DE L'UTILISATEUR.
PARA REDUCIR EL RIESGO DE LESIONES, EL USUARIO DEBE LEER EL MANUAL
DEL OPERADOR.

Summary

Important Safety Instructions

Assembly

Removing Battery Pack from Tool

Remove battery pack by pushing release buttons and pulling it away from the tool.

Inserting Battery Pack into Tool

Slide battery pack onto tool body until it latches securely into place.

Adjusting the Pivot Head

Pivot head range of 140°; 110° up and 30° down with detents every 10°.

Replacing the Bulb

Remove battery pack, unscrew bezel, pull heat sink, remove bulb. Use soft cloth for installation.

Operation

Clip-Lok System

The Clip-Lok system consists of two pieces: the belt clip and the tool holder.

Attaching the Belt Clip

Mount the belt clip to tool belts, bags, or buckets by pulling the clamp release and sliding the clamp.

Using the Clip-Lok Tool Holder

Attach tool by sliding holder onto belt clip stud until pin engages. Release by pushing tool release lever.

Maintenance

Maintain Work Light

Adopt a regular maintenance program for your work light, battery pack, and charger.

Accessories

Accessory Usage Guidelines

Only use accessories specifically recommended for this tool, as others may be hazardous.

Milwaukee WORK LIGHT Specifications

General

Brand	Milwaukee
Model	WORK LIGHT
Category	Work Light
Language	English