MIMAKI CG-130AR - Page 125

Chapter 4 Helpful Tips
125
Item
Setting
*1
Details
Authentication
[Auth.]
OFF/POP before
SMTP/SMTP Auth.
Sets the SMTP server authentication method.
User Name
[User Name]
Alphanumeric
characters or symbols
(Not more than 30)
Sets the user name used for authentication.
• This can be set when [Auth.] is not set to "OFF".
Pass Word Alphanumeric
characters or symbols
(Not more than 15)
Sets the password used for authentication. The value
currently set is not displayed on the password setting
screen. Only a new password can be entered.
• This can be set when [Auth.] is not set to "OFF".
POP3 Addr. - Sets the POP server. Set the server name or IP
address.
• This can be set when [Auth.] is set to "POP
before SMTP".
APOP ON/OFF Enables and disables APOP.
• This can be set when [Auth.] is set to "POP
before SMTP".
Transmit Test
[Test]
- Sends a test email.
*1. The default settings are shown underlined.
l
Enable the event email function.
1
Press the [FUNCTION] key in local mode.
2
Use to select [SET UP], then press the [ENTER/HOLD] key.
3
Use to select [EVENT MAIL], then press the [ENTER/HOLD] key twice.
4
Select [ON] on the [Delivery] screen, then press the [ENTER/HOLD] key.
5
Press the [END] key several times to exit.
l
Set the event for which event emails are to be sent.
1
Press the [FUNCTION] key in local mode.
2
Use to select [SET UP], then press the [ENTER/HOLD] key.
3
Use to select [EVENT MAIL], then press the [ENTER/HOLD] key.
4
Use to select [Event], then press the [ENTER/HOLD] key.
5
Use to enable or disable [PlotStart Event], [Plot End Event], [Warning Event], and [Error
Event], then press the [ENTER/HOLD] key.
• For more information on individual events, refer to "Event email setting item list"(P. 124).
6
Press the [END] key several times to exit.
4